Precautions for the use of compressed natural gas regulator

CNG Regulator compares the measured value of the production process parameter with the given value, and after the deviation is obtained, the output signal is generated according to a certain regulation law to push the actuator to eliminate the deviation, so that the parameter is maintained near the given value or changes according to a predetermined law Controller.
The regulator is a device that adjusts the voltage. First, it prevents the battery from being damaged by excessive voltage. At the same time, it cuts off the line with the battery when the generator voltage is too low. The above is a DC generator. If it is an alternator, it only has a voltage stabilizing function.
Use and maintenance of CNG Regulator:
1. Remove the protective shell and check whether there is dirt or burnt on the contact surface. If there is dirt, wipe the surface of the contact with clean paper. If the contact is ablated or the flat surface is not flat, resulting in poor contact, generally use "00" sandpaper or sand strip to smooth it, and finally wipe it with clean paper.
2. Check the firmness of each joint, measure the resistance and the resistance value of each coil. If it is damaged, it should be repaired or replaced with new parts in time.
3. Check the closing voltage and reverse current of the circuit breaker, the limit voltage of the regulator, the limit current of the throttle, and the gap and air gap of various contacts. If it does not meet the requirements, it should be adjusted.https://www.lnautogas.com/product/cng-regulator/